Carrier Weathermaker – 48KC Commercial Rooftop Units

48KC WEATHERMAKER® rooftop units were designed by customers for customers. With a gauge plug, centralized control center, plug & play accessory board, “no-strip screw” collars, and handled access panels, we’ve made the unit easy to install, easy to maintain, and easy to use. Units are pre-wired and pre-charged with Puron® (R-410A) refrigerant at the factory. The units are factory tested in both heating and cooling modes.

  • 3 to 5 Nominal Tons

Performance Features

  • ASHRAE 90.1 compliant
  • Single-stage cooling capacity control
  • Up to 14.1 SEER and 12.0 EER
  • Gas efficiencies up to 82%
  • Cooling operating range up to 115 °F (46°C) and down to 25°F (-4°C) using winter start kit
  • Innovative non-corrosive composite condensate pan in accordance with ASHRAE 62 Standard, sloping design; side or center drain
  • Exclusive IGC solid-state control for on-board diagnostics with LED error code designation, burner control logic and energy saving
  • indoor fan motor delay
  • Pre-painted exterior panels and primer-coated interior panels tested to 500 hours salt spray protection

Maintenance Features

  • Control terminal board facilitating simple safety circuit troubleshooting and simplified control box arrangement
  • Access panels with easy grip handles
  • Innovative, easy starting, no-strip screw feature on unit access panels
  • Tool-less filter access door
  • Optional hinged access panels also available
  • Direct Drive – ECM indoor fan motor standard with optional belt drive systems available
  • Two-inch disposable return air filters

Installation Features

  • Same footprint as installed Carrier 3-5 ton rooftops back to 1989, reducing installation costs and time
  • Field convertible from vertical to horizontal airflow configuration
  • Provisions for thru-the-bottom power entry capability as standard
  • Single point gas, electric, and controls connections
  • Full perimeter base rail with built-in rigging adapters and fork truck slots

Reliability Features

  • Scroll compressors with internal line-break overload protection
  • 24-volt control circuit protected with resettable circuit breaker
  • Permanently lubricated evaporator-fan motor
  • Totally enclosed condenser motors with permanently lubricated bearings
  • Low pressure and high-pressure switch protection
  • Exclusive IGC anti-cycle protection for gas heat operation
  • Solid-state electronic direct spark ignition system and flame roll-out safety protector

Standard Limited Warranty

  • 10 years parts only heat exchanger – aluminized
  • 15 years parts only heat exchanger – stainless steel
  • 5 years parts only compressor
  • One year parts only on all other parts
  • Additional extended warranty packages available
Carrier Weathermaker – 48KC Commercial Rooftop Units was last modified: August 3rd, 2023 by HVAC Expert
Nominal Cooling Ton Size Cooling Stages AHRI Efficiency (SEER) EER Dimensions (in) LxWxH Low Gas Heating Input (MBtuh) Medium Gas Heating Input (MBtuh) High Gas Heating Input (MBtuh) Approx. Unit Weight (lbs)
3 1 (14.0) 74x47x33 72 115 490
4 1 (14.0) 74x47x33 72 115 150 544
5 1 (14.1) 74x47x41 72 115 150 597

Reviews

There are no reviews yet.

Be the first to review “Carrier Weathermaker – 48KC Commercial Rooftop Units”

Options

Factory-Installed Field-Installed
Cabinet
Thru the base electrical or gas line connections X X
Hinged access panels X
Coil Options
Cu/Cu indoor and/or outdoor coils X
Pre-coated outdoor coils X
Premium, e-coated outdoor coils X
Humidity Control
Humidi-MiZer adaptive dehumidification system (3-phase models only) X
Condenser Protection
Condenser coil hail guard (louvered design) X X
Controls
Thermostats, temperature sensors and subbases X
PremierLink DDC communicating controller X X
RTU Open multi-protocol controller X X
Smoke detector (supply and/or return air) X
Time Guard II compressor delay control circuit X
Filter status switch X
Fan status switch X
Economizers & Outdoor Air Dampers
EconoMi$er IV (for electro-mechanical controlled RTUs) X X
EconoMi$er X (for electro-mechanical controlled RTUs with CA Title 24 FDD) X X
EconoMi$er 2 (for DDC controlled RTUs) X X
Ultra-low leak economizer dampers X X
Motorized 2-position outdoor air damper X X
Manual outdoor dir damper X
Barometric relief X X
Power exhaust X
Economizer Sensors & IAQ Devices
Single dry bulb temperature sensors X X
Differential dry bulb temperature sensors X
Single enthalpy sensors X X
Differential enthalpy sensors X
CO2 sensor (wall, duct, or unit mounted) X X
Gas Heat
Liquid propane (LP) conversion kit X
High altitude conversion kit X
Indoor Motor & Drive
Multiple motor and drive packages X
Low Ambient Control
Winter start kit X
Motormaster head pressure controller X
Power Options
Convenience outlet (powered) X
Convenience outlet (unpowered) X
Non-fused disconnect X
Roof Curbs
Roof curb 14″ (356mm) X
Roof curb 24″ (610mm) X

People like you shared their purchase and installation experience!

Richard G.Richard G.

When my furnace broke down last winter, we were without heat for two weeks while the HVAC company sourced the parts from the US. I wanted to install a gas fireplace insert to replace my existing gas log set and to act as a backup heat source (e.g. furnace breaks down again, no power). I had a number of questions about the various gas fireplace inserts (e.g. size and fit in my old fireplace) and I contacted several HVAC companies.

I found that Brian from Cozy Comfort Plus to be the most helpful and he also gave me the best price. I was home at the time and I saw that the Cozy team did a great job installing the gas fireplace insert (e.g., assembling and fitting the insert, bending and capping the chimney, etc.). If you are looking for a gas fireplace insert, I would highly recommend that you give Brian a call.

Read More
Jon ConwayJon Conway

We are so happy with the service, support and product that we received from Cozy Comfort Plus. Brian was incredible to work with, he took the time to understand what we were looking for and helped us with the designs and what the best fireplace for us might be. He is extremely easy to work with, very easy to communicate with and so fast and responsive!

Everything happened exactly on schedule and as planned. It was a well oiled machine!! The crews that were here to build everything were super friendly, kind, courteous and knowledgeable.

Highly highly recommend to all 😀👍

Read More
Michelle ZornMichelle Zorn

I had the most fabulous experience with Cozy Comfort Plus! Brian was very responsive for my first outreach all the way through to the completion of my beautiful fireplace! I live in a condo and as such, things are not straightforward when it comes to having work completed. There were a few extra hoops to jump through but Brian and his team were very diligent in ensuring that all the fittings were correct. I was so happy with my experience that I had them replace my furnace and add a smart home thermometer as well! I would highly recommend Brian and his team for their knowledge, skill and excellent customer service!

Read More